Model R Medium Wave Dryers For Sheetfed Presses

The Model R series dryer uses medium wave infrared elements mounted across the sheet. The model R dryer is used in low pile sheetfed presses or as a less expensive medium wave system on a high pile press.

Soneko Model R series infrared dryers are available in two configurations: The model R-3,4,and 5 are modular in design to allow for maximum flexibility of installation in low pile sheetfed presses. They can be installed in virtually any low pile press. The model of the press will determine the configuration required.

This system is specifically designed for presses that will not accommodate a panel type dryer such as the Heidelberg K, S, &M line presses.

The Model R is also available in a panel configuration as an R-4, R-5 or R-6. Standard panel thickness is only 1 1/4 " so this type of dryer is suitable for many presses that have difficulty with gripper clearance. A panel thickness of 1" is also available on special order.

The Model R is a dedicated medium wave system that is convection cooled (does not require outside cooling) with phase angle fired SCR control and impression and emergency stop controls, all as standard equipment.

Soneko IR, Inc., 220 Lincoln Blvd. Suite D, Middlesex, NJ 08846. Tel: 732-271-1710; Fax: 732-271-3398.